David Turnbull · Verified purchase
21 May 2026
Reviewed product: Alien Fused Clapton Dual
Another set of perfect coils from the Rev. incredibly helpful and friendly, even makes coils to order. Can't ask for more than that 10/10
Made To Order Coils
HALF PITCHFORK COIL
Wicked Wires UK Half pitchfork Coils made by revwrapz, half pitchfork Coils are a very flavourful (due to the ni80 fuse) and dense cloud producing coil, they offer an advanced perf...
Product details
Wicked Wires UK Half pitchfork Coils made by revwrapz, half pitchfork Coils are a very flavourful (due to the ni80 fuse) and dense cloud producing coil, they offer an advanced performance with denser clouds and a more thicker flavourful vape due to the 11 layers of ribbon wire found within the coil at a lower ohm range (.10+). a good coil for vapers who like to vape at the .10-.15 ohm range
kanthal .4 ribbon wire cores with ni80 round wire fuse
Sold in pairs
* Post-fire pulse:
* 6 wrap / 3mm ID:
* Single coil: 0.20-.26Ω
* Dual coil: 0.10-13Ω
All wicked wires uk coils are sterilised prior to packing and go through a triple stage quality check process before being packaged for postage to our customers.
WHOLESALE AVAILABLE UPON REQUEST "CONTACT US"
How to install
Some coils may ohm lower than your device can fire (staggertons .08-.10Ω, framed staples .12Ω) in this instance it is advised to fit one coil at a time, if using a regulated device use a low wattage, 15-25 watts depending on the ohm of the coil,trim the legs of both coils to the desired length required by your device, fit each coil to its dedicated posts ensuring you are using the correct posts for your device.
Ensure all coil legs are cut to length evenly, correctly and any trailing wires have been removed. Check that none of the coils are touching any of the externals of the rda they are fitted too or the 510 pins for single coil setup devices.
It is advised to now remove the grease and oils that have been applied to the coil from your hands during fitting, by either using an ultra sonic cleaner or some hot soapy water and a clean small soft nylon brush to clean the coils (remove from vape device when doing this) give the coils a good rinse in hot water and refit to your vape device at a low wattage.
Ensure that post screws are not tighten too tight as this can damage the legs on more fragile coils such as fused staples and cause the legs to snap at the post holes, this can also cause the coil to read incorrect ohms when in use (some fluctuation of final ohms readings are a good indication of damage caused by incorrect fitting in this manner, usually seen at the re-wick stage of coil care and a good indication of coil replacement needed)
Once happy with the fit of the coils check there are at the same height as the air flow holes on your rda cap, by inserting the coiling tool and gently lifting or lower the coil into place, again making sue that both coils are not touching any parts of the rda accept where they are secured into the post holes.
Apply power to the coils and bring to a gentle amber glow, hot spots may appear in the form of bright white/red spots, to remove these, discontinue applying power to the coils and strum the coils using your ceramic tweezers, or pull the individual coils of the coil apart (hot spots are generally caused by the individual coils of the coil touching and causing a short)
how to maintain wicked wires uk coils.
If you find you have one coil heating quicker then another, check both coils are set at the same distance from the posts that they are connected to, check the ID (inner diameter) of each coil has not been changed due to the fitting process, by using the correct size coiling tool and gently tugging on each coil to correct that coils ID.
(ensure the coils are secured in place correctly before doing this, wicked wires uk is not responsible for any damage caused to coils during the fitting process, we advise only experienced vapers use our coils due to this)
After some use the coils may begin to look a little black or dark, this can easily be cleaned off by using some of the following steps.
Take your rda off of your device and put onto an ohm reader or a regulated device with fully charged batteries (DO NOT PERFORM THIS STAGE ON A MECHANICAL DEVICE)
Gently dry burn your coils by removing your wick, apply low power to your coils at around 20-30 watts to produce a low amber glow, as this occurs any sugars that have built up on the coils should burn away, once this begins release the power on your device and set to one side to allow the device and the coils to cool naturally.
(DO NOT RUN UNDER WATER)
Once the device and coils have cooled, remove your rda/rdta from your device, take to a sink and wash the coils and rda with a soft nylon brush (toothbrush works well) and some warm soapy water, with more complex coils be gentle if using this process to clean coils. give the coils and rda a good rinse with clean warm/hot water and shake off excess water before fitting back to your device.
(wicked wires uk recommend you use an ultra sonic cleaner for long term solution for this process with 2 or 3 cycles run if possible)
You should now perform the same steps as you did when you fitted the coils from new, to ensure all the screws in the posts are still tight after being cleaned, that the coils themselves have not degraded to a state that they require replacing, check the integrity of the insulators on your rda before applying power to it again, check that the 510 pin on the rda/rdta is correctly tightened and then re-glow both coils to ensure they are glowing evenly (if in doubt follow the first steps in these how to tips)
Once happy with the cleanness and fit of the coils allow to cool, re-wick and vape!
(wicked wires uk is not responsible to damaged caused to coils/rda/rdta/mods or any individual due to incorrect fitting, or caused due to general maintenance or use of wicked wires uk hand made coils, the information and tips described above are to be used at the customers own risk and as a general how to guide, you should be sure you have sufficient knowledge of ohms law, correct battery safety and general use. That you have a good understanding of how to use rebuild-able vape devices and when purchasing wicked wires uk coils you do so at your own risk)
Product Type
Coil Build Type
Wire Material
- This product sits in the Made To Order Coils range.
- The displayed stock is used to keep basket quantities honest.
- If you need anything clarified before purchase, contact support with the product name and any option or delivery details.
- Shipping options are calculated during checkout based on basket and address.
- Orders are packed carefully before dispatch, with delivery and return details available on the Delivery & Returns page.
- For pre-purchase questions, use Contact & Support and include the product name so we can help faster.
Stock
In stock
Estimated delivery in 1-2 days
Free shipping over £34.50 with Standard 1st Class Small Parcel.
14-day returns window
Return postage arranged by customer
Secure payment
Secure checkout with PayPal.
HALF PITCHFORK COIL
£12.00 · In stock
Customer reviews
What customers say about Wicked Wires
This product has no reviews yet. These reviews are from purchases across our store, not reviews of this product.
Every public review comes from a real paid order and is held for moderation before it appears here.
Write a review for this productSign in to see your review invitations, or use the review link emailed after your purchase.
5.0
4 store reviews
David Turnbull · Verified purchase
21 May 2026
Reviewed product: Alien Fused Clapton Dual
No Ai here.. High quality coils from the Rev again. My goto for them glowing things that go in your atty.
Really good coils
Robert · Verified purchase
18 May 2026
Reviewed product: 12 Ply Staggerton Single
The coils are spot on I asked if they could make them 3.5 id to go in a bonza pro rta (I prefer single coil setup) the flavour is amazing from these coils will definitely be getting more from them in the future 👍
Excellent service and quality
Christopher · Verified purchase
16 May 2026
Reviewed product: Coil Bundle 4
Ordered this after purchasing a new Hammer of God and The Valhalla RDA, ordering was easy, items arrived very quickly and the coils are top quality, I'm now back chucking clouds and setting off the smoke alarms thanks to the guys at wickedwires, highly recommended and will definitely be a return customer when I need more coils in the future.
More in Made To Order Coils
